Mathematical Modeling of The Machining Process of White Cast Iron
Keywords:
White cast iron, mechanical machining, mathematical modelAbstract
This paper presents a mathematical model in the form of complex differential equations describing the mechanical cutting of white cast irons. Heat conduction PDE, similarity criteria theory (Peclet, F, D), and mechanical cutting theory were applied. A system of six interrelated equations was developed covering geometry, temperature, forces, plasticity, wear, and heat balance. Conclusion: The model enables justification of tool material requirements for machining white cast irons.
References
Urtekin L., Sahin I.B., Yilan F. et al. Investigation and Optimization of Cutting Performance of High Chrome White Cast Iron by Wire Erosion // Arabian Journal for Science and Engineering. — 2024. — Vol. 49. — P. 1585–1596. DOI: 10.1007/s13369-023-07930-6
Nelwalani B.N., van der Merwe J., Munyangane V. et al. On the influence of compositional variations in high chrome cast iron: an assessment of microstructure and mechanical behaviour // Manufacturing Review. — 2024. — Vol. 11. — P. 9. DOI: 10.1051/mfreview/2024001
Hao G., Liu Z. The heat partition into cutting tool at tool-chip contact interface during cutting process: a review // The International Journal of Advanced Manufacturing Technology. — 2020. — Vol. 108. — P. 393–411. DOI: 10.1007/s00170-020-05404-9
Suresh R., Basavarajappa S., Samuel G.L. Some studies on hard turning of AISI 4340 steel using multilayer coated carbide tool // Measurement. — 2012. — Vol. 45, № 7. — P. 1872–1884. DOI: 10.1016/j.measurement.2012.03.024
Chinchanikar S., Choudhury S.K. Predictive modeling for flank wear progression of coated carbide tool in turning hardened steel under practical machining conditions // The International Journal of Advanced Manufacturing Technology. — 2015. — Vol. 76. — P. 1185–1201. DOI: 10.1007/s00170-014-6285-6
Rosa S.D.N., Diniz A.E., Andrade C.L.F. et al. Analysis of tool wear, surface roughness and cutting power in the turning process of compact graphite irons // Journal of the Brazilian Society of Mechanical Sciences and Engineering. — 2010. — Vol. 32, № 3. — P. 234–240. DOI: 10.1590/S1678-58782010000300010
Zhu K. Modeling of the Machining Process // Smart Machining Systems. Springer Series in Advanced Manufacturing. — Cham: Springer, 2022. — P. 25–68. DOI: 10.1007/978-3-030-87878-8_2
Soori M. et al. Cutting tool wear prediction in machining operations, a review // Journal of New Technology and Materials. — 2022. — Vol. 12, № 1. — P. 1–19.
Grzesik W. Advanced Machining Processes of Metallic Materials: Theory, Modelling and Applications. — 2nd ed. — Amsterdam: Elsevier, 2017. — 606 p.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2026 A.Allanazarov, A.X.Axmedov
This work is licensed under a Creative Commons Attribution 4.0 International License.
